| Info |
|---|
This article will go over the steps to run the Inventory Inspection report and will go over the filtering options. This report requires the Quality Control module to work. For more information on how to add the Quality Control module to your Croptracker account, contact support@croptracker.com. |
Step-by-step Instructions
1. From the Dashboard, select the Reports page.
...
2. On the Reports page, select Inventory Inspection Report.
...
3. Filter the Report for the appropriate date range, select the Inspection Template you would like to report on and, optionally, select an inventory tracking code. See screenshots below of report description and filters.
...
4. The report will generate given selected filters and can be exported using the export button in the table.
...
*Note: The report table can get quite large depending on how much information is in the given inspection template. Scroll using the bar at the bottom of the report table to see the whole table.
...
Report Columns
Inspection -date the inspection was created
Harvest Date -date the inventory being inspected was harvested/created within Croptracker (if inventory is not attached, this column will be blank)
Variety -the variety of the inventory being inspection (if inventory is not attached, this column will be blank)
Harvest Location -the block/growing area the inventory came from (if inventory is not attached, this column will be blank)
Lot Code -the lot code of the Quality Control event
Tracking Code -tracking code of inventory created in Croptracker (if inventory is not attached, this column will be blank)
Scan Code -code generated in Croptracker of scan inspection is attached to (if this inspection is not attached to a scan, this column will be blank)
Status -the status of the inspection
Specimens -the number of specimens in the inspection
*Remaining columns in the report will be depend on the format of the Inspection Template being reported on. See screen recording above for format example for each spec type.